Introduction
The Vyper–KV102 II is an ultra–flat passive loudspeaker comprised of sixteen 1” neodymium magnet transducers each, housed in an elegant yet sturdy aluminum chassis, with a new frameless chassis designed for very elegant discreet installations, perfect for a clean bracketless application on any flat surface.
The sixteen closely–spaced cone drivers provide true line array characteristics: phase coherence, low distortion and focused listening in both the near field and at a distance from the speaker.
Two different values ofimpedance (8Ω – 32Ω) allow to connect up to 8x Vyper–KV102 II loudspeakers at 32Ω impedance to the same 4Ω amplifier output channel, which eliminates the need for 70V lines for wide distributed installed systems where pristine sound, intelligibility and elegance are mandatory.
KV102 II black model
KV102W II white model
KV102X customizable RAL color and finish (box + grille)
new! KV102M II, KV102MW II, KV102MX II (only RAL colors) = MARINE TREATMENT (on request)
All Vyper–KV102 II components are designed by the K–array RD department and are custom–made under the K–array quality control system in Italy.
Technical sheet
Specifications
General
-
Type:
Line array
-
Transducers:
16x 1” Neodymium magnet woofers
-
Frequency Response:
150 Hz – 18 kHz (–6 dB)
(1) -
Max SPL:
120 dB peak
(2) -
Rated Power:
300 W
-
Coverage:
V. 7° | H. 140°
-
Connectors:
2PIN euroblock connector (included)
-
Nominal Impedance:
8 Ω – 32 Ω
-
Weight:
1,8 kg (3.96 lb)
Handling and Finishes
-
Dimensions (W x H x D):
40 x 1000 x 22 mm (1.6 x 39.3 x 0.9 in)
-
Material:
Aluminum
-
Colors:
Black, White, Custom RAL
-
Finishes:
24K Gold, Polished
Regulations
-
IP rating:
IP65
- (1) With dedicated preset
- (2) Maximum SPL is calculated using a signal with crest factor 4 (12dB) measured at 8 m then scaled at 1 m
-
Passive loudspeakers require dedicated presets loaded onboard K–array amplifiers.
New materials and design are introduced into existing products without previous notice.
