Vyper-KV25 II

Ultra–flat aluminum line array element

After-sales service 6 days a week
Free quote
Free delivery

Introduction

The Vyper–KV25 II is an ultra–flat passive loudspeaker comprised of four 1” neodymium magnet transducers each, housed in an elegant yet sturdy aluminum chassis, with a new frameless chassis designed for very elegant discreet installations, perfect for a clean bracketless application on any flat surface.

Les quatre haut–parleurs à cône rapprochés offrent de véritables caractéristiques de ligne source : phase coherence, low distortion and focused listening in both the near field and at a distance from the speaker.

Two different values ofimpedance (8Ω – 32Ω) allow to connect up to 8x Vyper–KV25 II loudspeakers at 32Ω impedance to the same 4Ω amplifier output channel, which eliminates the need for 70V lines for wide distributed installed systems where pristine sound, intelligibility and elegance are mandatory.

The main product models and codes are:

KV25 II black model

KV25W II white model

KV25X couleur et finition RAL personnalisables (boîtier + grille)

new! KV25M II, KV25MW II, KV25MX II (only RAL colors) = MARINE TREATMENT (on request)

All Vyper–KV25 II components are designed by the K–array RD department and are custom–made under the K–array quality control system in Italy.

Technical sheet

Specifications

General

  • Type:

    Line array

  • Transducers:

    4 x 1″ woofers à aimant néodyme

  • Frequency Response:

    150 Hz – 18 kHz (–6 dB)

    (1)
  • Max SPL:

    108 dB (peak)

    (2)
  • Rated Power:

    75 W

  • Coverage:

    V. 25° | H. 140°

  • Connectors:

    2PIN euroblock connector (included)

  • Nominal Impedance:

    8 Ω / 32 Ω selectable

Handling and Finishes

  • Dimensions (W x H x D):

    40 x 260 x 22 mm (1.56 x 10.24 x 0.85 in)

  • Weight:

    0.4 kg (0.88 lb)

  • Material:

    Aluminum

  • Colors:

    Black, White, Custom Ral

  • Finishes:

    24K Gold, Polished

Regulations

  • IP rating:

    IP65

  • (1) With dedicated preset
  • (2) Maximum SPL is calculated using a signal with crest factor 4 (12dB) measured at 8 m then scaled at 1 m
  • Passive loudspeakers requires dedicated preset loaded on board of K–array amplifiers.

    New materials and design are introduced into existing products without previous notice.

Recommended for you